Description:(The usage of this item is illigal in USA territory, for this reason we don't ship any 1.2 GHz transmitters to USA addresses)
Do you have a 2.4 Ghz Radio Control, and want to make a video with your model, without concern of interference?
Then what you will need is the FPV1012 complete Audio and Video wireless system.
It is is a complete plug and play wireless system set, and within few seconds you have everything connected and working wirelessly.
This combo uses PLL (Phase-Locked Loop) technology to prevent frequency drift.
The plug and play board has lots of important features built-in such as:
- High quality microphone
- Audio volume control
- High quality 5v voltage regulator (no heat and noise free)
- Reverse-Polarity Protection (avoids damage if you plug the battery pack inverted)
- Dual power output (provides selectable power for 5 and 12 volts cameras)
- Molex connector with safety latch (prevents connection to come loose while in use)
- Power LED (helps to identify bad power connection, reminds you to disconnect power when it’s not in use)
The transmitter six (6) selectable channels and it is a powerhouse providing 1000 milliwatts of pure RF output, perfect for long range applications and even with all this power it only weights around 1oz (30g).
It’s highly recommended to install the transmitter as far as possible from the model's receiver, also highly recommended to install the transmitter in ventilated areas, to allow air flow to keep it cool.
The transmitter can be powered through a JST connector and the receiver using a regular power plug. Any power source from 10.5 to 13 volts DC, example a 3S 11.1v lithium battery will perfectly power your system.
To get the most performance out of this system using a high gain antenna for the receiver, and it will not only increase the range but the quality of the reception as well.
The receiver has high sensitivity providing an extraordinary signal reception, this quality of reception is part of the success of this wireless system. It is also very compact and it can be used with any of our 1.2 GHz antennas.
Now you can add your favorite camera to this combo, by just selecting it from a list below. There is no hassle to connect it, just Plug and Play.
Package includes:
-Transmitter 1.2 GHz 1000mW with built-in microphone
- High Sensitivity Receiver R1200-STD Standard 1.2 GHz receiver * (upgrade is available below).
- Power Plug for receiver is included
- Works with any camera PAL or NTSC
- Audio and video output cable with RCA connectors
- 2x whip antennas
- Camera is not included, but you can add your favorite camera to plug and play with this combo, see the options below
Specifications:
Nominal output impedance: 50 ohms
Operating Voltage: 10.5 - 13 volts DC
Consumption Current 450mAh
Video input voltage
75-ohm impedance: 1Vp-p
Audio input voltage
10k ohm impedance: 1Vp-p
Sub carrier frequency: 6.5MHz
Operation temperature: -10 to 40 degrees Celsius
Storage temperature: -40 to 80 degrees Celsius
Operating humidity: 20 to 80%
If you are not going to run your RC model, do not turn this transmitter on and leave it on for several minutes, it can overheat damaging the unit!
It is 1000mW transmitter in a tiny metal box!!!
The 1.2 Ghz transmitter is not available within US territory due to country's rules, nor it will be shipped to any address within US territory.
This product was added to our catalog on Friday 05 December, 2008.
