DH-U combo DHT-U 2.4GHz telemetry system.
It's a duplex built-in receiver and 2.4 GHz transmitter module. Just to receive telemetry data from your RC model and control the model at the same time.
All-in-one universal telemetry module, combination of DHT, in-built display and fdd_lite, which can be clamped to the transmitter handle or antennas base.
Show in-flight data via in-built display;
Capable of setting failsafe during flight.
Voltage (voltage sensor connecting to sensor hub)
Longitude & Latitude
V8_Mode (non-telemetry)/D_Mode (telemetry)
Bind/Normal Working/Range Check
Voltage Division Ratio (selectable): A1/A2/Voltage
sensor connecting to sensor hub
Unit Set (selectable): Speed (m/s or MPH)
Temperature (Celsiu or Fahren)
Alarm Set: A1_1/2, A2_1/2, RSSI_1/2
The alarm thresholds and directions (either above or below threshold) can be programmed by using FrSky LCD-fdd_lite. After alarm thresholds and directions are programmed, click “SEND”. If programmed values keep unchanged, that means these values have been remembered.
Compatibility: FrSky DFT, DJT and DHT
- Model: DHT-U
- Operating Voltage Range: 6.0V-13.0V
- Operating Current: 50mA
- Output Power: 60mW
- Resolution: 3072 (>11bit)
- Weight: 74g
- 1) All-in-one combination of telemetry module,in-built display and alarm threshold settings
- 2) DHT-U can be clamped to the transmitter handle/antenna
- 3) Show in-flight data via in-built display
- 4) Capable of setting failsafe during flight
- 5) Firmware upgradable
- 100% Brand New
- 1 x DHT-U 2.4GHz Two Way Series
- 1 x instruction Manual
Pin out fo PPM
Watch some tutorial videos over youtube.
||Two Way Series
|Pins Definition for PPM Signal
Note: Due to incaution, pins definition for Aurora 9 on the guide sheet of "Pins Definition for PPM Signal" going with certain DHT-U combo was mislabeled. Click here to see correction.
All technical questions about FrSKy products must to be emailed to firstname.lastname@example.org