THIS ITEM HAS BEEN REPLACED BY A NEWER VERSION, T1013 EAGLE. CLICK LINK BELOW.
The T1013 V2 has been completely redesigned and tailored for FPV with a handful of improvements, such as: new switching regulator, ceramic high efficency low profile heat sinks, high quality audio channel, runs 50% cooler than its previous model, lower profile, 10 grams lighter and overall better performance.
It's a power house, providing a 500/1000 milliwatts of pre RF output. It is the best transmitter for long range applications. (for RC models is recommended to install the T1013 as far as possible away from the models receiver) Even with all that power, it weights only around 0.8oz (25grams). With all this, and the right setup, for sure you can get video reception miles away. It is highly recommended to install the transmitter in ventilated areas, to allow the air to keep it cool. As any of our transmitters, T1013 V2 has digital Phase-Lock-Loop circuit avoiding frequency drift, providing a stable and solid audio and video delivery. You can not go wrong with it.
500/1000mW RF output power
(2) User-selectable US channels (1258MHz and 1280MHz)
1.3 GHz frequency band
Works with any camera PAL or NTSC
Digital Phase-Lock-Loop circuit no drifting problem
Works with any of our receivers
Audio and Video cable with RCA adapter
Highly integrated circuit
High reliability/linearity/AIGaAs/GaAs FET amplifier module
Uses digital phase-lock-loop circuit without temperature drifting problem
Weight: 30g (transmitter only)
Output power 50-ohm load CH1 Vcc = 12V: 30dBm (1000mW)
Nominal output impedance: 50 ohms
Operating voltage: Vcc, 10.5V (minimum), 12V (typical), 13V (maximum)
Supply current Vcc = 12V: 350mA (typical), 400mA (maximum)
Video input voltage 75-ohm impedance: 1Vp-p
Audio input voltage 10k ohm impedance: 1Vp-p
Sub carrier frequency: 5.5MHz
Operation temperature: -10 to 40 degrees Celsius
Storage temperature: -40 to 80 degrees Celsius
Operating humidity: 20 to 80%
Storage humidity: 10 to 80%
Dimensions and weight: 50 x 26 x 11mm, 0.93oz (26g) (without antenna)
Standard shipping package:
1.3 GHz 500/1000mW AV transmitter (Lawmate's replacement)
SMA type dipole antenna x 1
Jack connector to RCA AV input and power input cable x 1
Click here to see the transmitter and camera connections.
Click here to see compatible receivers
Notes: It's illegal to ship the international version of this transmitter to an US address, retailer and recipient are subjected to $10,000.00 usd fine or more.
- No license is required to purchase it, however in order to legally operate within USA an amateur radio license is required.
- Make sure you use the "stylus" tool that comes as an inserted to the side of the receiver's case. Use the "stylus" tool to toggle the plastic DIP switches, the DIP switches can be damaged if improper tool is used.
Disclaimer: Hobby Wireless is not responsible any damage, loss, illegal operation or changes made by the user to the transmitter will be totally the user's responsibility.