This kit has everything you need to separate your mini quad's controller board from its' power distribution board. The parts are made from sturdy, impact absorbing nylon material. Because the parts are nylon the kit is very lightweight and easy to install. Your quad will be up and flying in minutes with virtually no chance of the boards touching each other and causing electronic shorting in your quadcopter.
4 pcs 3/16" (4.75mm) screws, nylon, right hand thread, slotted drive
4 pcs Nylon hex screw nuts
4 pcs Hex Standoff, Male-Female, UNC threads (right hand), Off-white, #4-40 screw size, 1/2" (12.7mm) length
4 pcs Hex Standoff, Nylon, Male-Female, UNC threads (right hand), Off-white, #4-40 screw size, 9/16" (14.28mm) length